Joined: 6 August 2008
Location: CN
Posts: 2

Back to Top

hello i want a negative slope between 5.25 deg and 89.25 deg in my application with 90316,from the datasheet i learned that, only after point C the slope could be negative, so my settings are as follows: A_X is 0 deg, A_S is 0 %Vdd/deg,A_Y is 95%Vdd, B_X is 5 deg, B_Y is 95%Vdd,B_S is 0 %Vdd/deg,C_X is5.25 deg, C_Y is95%Vdd,C_S is -1.0119%Vdd/deg, while i input these valuse,and click write to EEPROM, a messagebox said"succesful" shew up,but while i click read eeprom,the slope after C point,it is 1.165, and the output is incorrect. do u have some advice? thanks a lot! Best regards!

Joined: 6 August 2008
Location: CN
Posts: 2

Back to Top

Nobody knows?

Joined: 1 February 2006
Location: BE
Posts: 123

Back to Top

Hello

It is indeed correct that 90316/BCG can have a negative slope LNR_C_S.
If you use the correct software, i.e. UI 90316 BCG, then this should be possible.
I guess that you are using old UI 90316 BAD ?

Another possibility is to use the negative slope option in the UI or invert the rotating direction.

rg

JC Depoorter