Joined: 2 September 2008
Location: US
Posts: 1

Back to Top

I just got the kit. It has power and I think I'm trying to communicate with a functioning COM2 port. It won't respond to even a Version request. What can I be doing wrong. The manual is much less helpful than I expected.

Joined: 1 February 2006
Location: CH
Posts: 102

Back to Top

Dear,

If you are using the COM2, you may use the right part of the RS232 User Interface. Please be sure the corresponding COM port is open by clicking the button "OpenComX" and configured to br9600 by clicking on the "Setupcom" button (at the Bottom). After configuring the corresponding COM port, you have to load the list of command by clicking on the "ReadFileComX" button.

Please note that the left or the right part of the RS232 User Interface should be used according to the COM port (left for COM1 and right for COM2).
Could you try to use the COM1 instead of 2?

Best Regards
Denis